User`s manual

Agilent E1330B Digital I/O Module Command Reference 79
Chapter 5
DIGital:DATAn[:type]:HANDshake:DELay?
[SOURce:]DIGital:DATAn[:BYTE]:HANDshake:DELay? queries for the delay
time between data output and the control line for data output at 8-bit port n and
returns a decimal number between 0 and .015.
[SOURce:]DIGital:DATAn:WORD:HANDshake:DELay? queries for the delay
time between data output and the control line for data output at 16-bit port n and
returns a decimal number between 0 and .015.
[SOURce:]DIGital:DATAn:LWORd:HANDshake:DELay? queries for the delay
time between data output and the control line for data output at 32-bit port n and
returns a decimal number between 0 and .015.
Parameters
Comments • The delay time must be set to the same value on all ports used in a multiple
port operation.
• The keyword :LW32 may be used instead of :LWORd when using the
download version of the SCPI driver.
• DIG:DATAn[:type]:HANDshake is the sequence used for commands relating
to data handshaking at ports defined by n. The port number n must be the last
character of the keyword without spaces.
• MIN or DEF returns 0.000002. MAX returns 0.015.
Parameter Name Parameter Type Range of Values Default
DATA
n
Numeric BYTE
WORD
LWORd
none, 0, 1, 2, or 3
none, 0 or 2
none or 0
0
MIN|MAX|DEF Discrete None or MIN|MAX|DEF None