User`s manual

100 Agilent E1330B Digital I/O Module Command Reference
Chapter 5
[SOURce:]
DIGital:CONTroln:POLarity <POS|NEG>
DIGital:CONTrol
n:POLarity?
DIGital:CONTrol
n[:VALue] <0|1 or ON|OFF>
DIGital:CONTrol
n[:VALue]?
DIGital:DATA
n[:type]:BITm <0|1>
DIGital:DATA
n[:type]:BITm?
DIGital:DATA
n[:type]:HANDshake:DELay <time>
DIGital:DATA
n[:type]:HANDshake:DELay?
DIGital:DATA
n[:type]:HANDshake[:MODE]
<NONE|LEADing|TRAiling|
PULSe|PARTial|STRobe>
DIGital:DATA
n[:type]:HANDshake[:MODE]?
DIGital:DATA
n[:type]:POLarity <POS|NEG>
DIGital:DATA
n[:type]:POLarity?
DIGital:DATA
n[:type]:TRACe <name>
DIGital:DATA
n[:type][:VALue][<base>]<value>
DIGital:DATA
n[:type][:VALue]?
DIGital:FLAG
n:POLarity <POS|NEG>
DIGital:FLAG
n:POLarity?
DIGital:HANDshake
n:DELay <time>
DIGital:HANDshake
n:DELay?
DIGital:HANDshake
n[:MODE]
<NONE|LEADing|TRAiling|
PULSe|PARTial|STRobe>
DIGital:HANDshake
n[:MODE]?
Sets logical true level of control line on port
n.
Returns current logical true polarity of port
n.
Sets or clears control line on port
n. Command used to create
custom handshakes when HANDshake is set to NONE.
Returns the current state of the control line on port
n
(downloaded SCPI driver only).
Sets bit
m on port n.
Returns the programmed state of bit
m on the port n
(downloaded SCPI driver only).
Sets delay between data output and assertion of control line
for data output on port
n. Also sets strobe pulse for both
output and input STRobe handshake.
Returns the time between data valid and assertion of control
line to TRUE.
Selects type of handshake to transfer data between port
n
and peripheral. Handshakes are initiated by execution of
DIG:DATA
n or MEAS:DIG:DATAn? commands.
Returns the current handshake mode set on port
n.
Sets logical true level of the data lines on port
n.
Returns the logical true level set for the data lines on port
n.
Writes the named block of data to the port
n.
Writes the value, in the specified base, to port
n.
Returns a decimal value indicating the programmed state of
the data lines on the port
n (downloaded SCPI driver only).
Sets logical true level of the flag line on port
n.
Returns the logical true level set for the flag line on port
n.
Sets delay between data valid and assertion of control line for
data output on 8-bit port
n. Also sets strobe pulse for both
output and input STRobe handshake.
Returns the time between data valid and assertion of control
line to TRUE on 8-bit port
n.
Selects type of handshake to transfer data between 8-bit port
n and peripheral. Handshakes are initiated by execution of
DIG:DATA
n or MEAS:DIG:DATAn? commands.
Returns the current handshake mode set on 8-bit port
n.
Command Description