Service manual

14 Pacer
Overrun
Error
The pacer is in use and the pacer rate is faster than the
maximum A/D conversion rate based on integration time,
autorange setting, autozero setting, and interrupts enabled.
U
15 Input
Overload
A potentially damaging overload has been applied to the
multimeter terminals and the multimeter has disconnected
from the input. A new SET RANGE command is necessary to
restore normal operation. A damaging overload is defined as:
1. Applying > ± 40 volts Hl to LO or Hl to COMMON while in
manual range with RANGE ≤ 8 volts.
2. Applying > ± 40 volts between LO and COMMON under
any circumstances.
U
* U = improper operation, H = hardware failure
Adjustments 5-11