Manualshelf

Service manual

ManualsBrandsAgilent Technologies ManualsComputer HardwareE1300B
11121314151617181920
Multimeter
Specifications
Multimeter specifications are listed in Appendix A of the Agilent
E1326B/E1411B User’s Manual. These specifications are the
performance standards or limits against which the instrument may be
tested.
Multimeter
Serial Numbers
Multimeters covered by this manual are identified by a serial number
prefix listed on the title page. Agilent uses a two part serial number in
the form XXXXAYYYYY, where XXXX is the serial prefix, A is the
country of origin (A= USA) and YYYYY is the serial suffix. The serial
number prefix identifies a series of identical instruments. The serial
number suffix is assigned sequentially to each instrument.
If the serial number prefix of your instrument is greater than the one
listed on the title page, a Manual Update (as required) will explain how
to adapt this manual to your instrument. If the serial number prefix of
your instrument is lower than the one listed on the title page,
information contained in Chapter 7 (Manual Changes) will explain how
to adapt this manual to your instrument.
Multimeter
Options
There are no electrical or mechanical options available for the Agilent
E1326B multimeter. However, you can order Option 1BN which
provides a MIL-STD-45662A Calibration Certificate, or Option 1BP
which provides the Calibration Certificate and measurement data.
Contact your nearest Agilent Technologies Sales and Service Office for
information on Options 1BN and 1BP.
Field
Installation
Kits
An Agilent E1326B multimeter can be installed inside the Agilent
E1300B/E1301B mainframe (using one or two A-size slots). If you have
an Agilent E1326B multimeter, order installation kit E1326-80004 and
(optionally) installation kit E1326-80005.
As shown in Figure 1-2, the E1326-80004 kit provides the multimeter
front panel without binding posts. The E1326-80004 kit also contains
required hardware and installation instructions. The E1326-80005
installation kit adds another front panel with binding posts. (If you use
the E1326-80005 kit, a second A-size slot is required.)
1-4 General Information