User`s guide

Contents ▲ 72 ▼ Index
Running an Electrophoretic Assay
Running an electrophoretic assay in 2100 expert just means pressing a button.
NOTE
You can stop a chip run at any time, for example, if errors occurred, or if you are not
satisfied with the quality of the measurement results, which you can observe during
the chip run. See “Stopping a Chip Run” on page 77.
Starting the Chip Run
When you have loaded the chip, you can start the chip run:
1 On the Instrument tab, click the Start button.
The chip run starts. The Raw Signals sub-tab shows an electropherogram of the currently
measured sample. The name of the sample is displayed above the graph. The graph is a
“live” plot of the migration time against fluorescence units (raw data, including
background fluorescence, for example).