User`s guide

Contents ▲ 374 ▼ Index
Shows/hides the data points used to generate the electropherogram.
Data points are visible only in the single-well view. Data points are
0.05 seconds apart as the time resolution of the data points is 0.05
seconds, which corresponds to their data acquisition rate (of 20 Hz).
Shows/hides grid lines (single-well view only).
Puts a copy of the electropherogram into the clipboard (single-well
view). In multi-well view, all electropherograms are copied.
Opens a system dialog box allowing you to save the
electropherogram (single-well view) or all electropherograms
(multi-well view) as an image in JPEG (.jpg), Windows Bitmap (.bmp),
Windows Meta File (.wmf), CompuServe Graphics Interchange (.gif),
or Tagged Image File (.tif) format.
Switches to the manual peak integration mode.
In this mode, you can:
• change the start and end points and the baseline of a certain peak
• add or delete certain peaks from the integration.
See also “Manual Integration” on page 124.
Switches to the automatic peak integration mode (all manual
integrations will be lost).
Lets you choose the type of information peak labels show in
electropherograms. The labels are only visible in single-well view and
if the Peak Table sub-tab is selected.