User manual

Programmer’s Guide Page 9 of 64
2.2.2. AqDx Getting Started VI
This VI demonstrates how to use some of the basic components of the AqDx Acqiris Digitizer Driver. It finds and
initializes a digitizer, sets the basic parameters according to the controls on the front panel, and then acquires one
waveform. Note that the front panel controls should be set to their desired values before the VI is run.
2.2.3. AqDx Example Scope VI
This VI presents a basic, interactive virtual oscilloscope using the AqDx Digitizer Driver. Not all the functionality of
the Acqiris digitizers is supported in this program, but most of the most-commonly-used functions are demonstrated
in it.