Specifications

4
Test environment setup and test selection (continued)
The first setup screen is shown in
Figure 2 with the Start Project screen.
This is where the project information
and device specifics such as Test
device, and Test Type are entered. The
Test Type refers to whether the tests
to be selected from a subsequent
menu will be single ended tests only,
differential tests only, or both single-
ended and differential tests.
Device Definition
Critical information to guide the test
process will be the device capability
information. This is information about
the test device such as the valid levels,
pre-emphasis settings, number of
lanes, bit rates and whether spread
spectrum clocking is enabled or not.
These capabilities are identified in the
DUT Definition screen in Figure 3.
Figure 2: Start Project screen to enter standard test data and select
Test Device Type and Test Type. Shown is Test Type = Both to support
single-ended and differential tests.
Figure 3. DisplayPort EPVC software DUT Definition Entry in Setup