Technical data

Getting Started 1
Product at a Glance
U3606A User’s and Service Guide 19
The terminals at a glance
Figure 1-7 U3606A connector terminals
[3] The continuity and diode test functions have a fixed 4½ digit resolution. Capacitance measurement is fixed to 3½ digit
resolution.
[4] The sweep functions can only be accessed when the U3606A is in constant voltage or constant current mode. You cannot
access the sweep functions while the U3606A is in square-wave output mode.
[5] The overcurrent and overvoltage protection features are only active when the output protection state is enabled. See
Chapter 4, “Setting the output protection state,” starting on page 122 for more information.
[6] You can only change the range when the instrument output is in the “standby” state (the SBY annunciator is illuminated).
CAUTION
To avoid damaging this device, do not exceed the rated input limit.
Positive input terminals (V, , , )
Positive input terminals (I)
Positive output terminals ( )
Negative output terminals ( )
Negative input terminals (LO)
Current input fuse