Technical data

System Related Operation 4
Utility Menu Summary
U3606A User’s and Service Guide 125
8 After configuring the ramp signal parameters, press Shift > Save to save
or press Shift > Exit to exit the edit mode without saving.
9 Press Shift > Exit to exit the utility menu.
Configuring the scan signal parameters
The following procedure shows you how to configure the scan signal
parameters.
1 To access the utility menu, press Shift > Utility.
2 The first utility menu item (Error) will be shown in the upper
secondary display.
3 Press or until the menu item “SCAn” is shown in the upper
secondary display.
4 Press Voltage or Current if you wish to configure the scan signal
parameters for CV or CC output. (The CV or CC annunciator
illuminates respectively when selected.)
Table 4 - 4 Scan signal parameters
Scan signal Output
Items Constant Voltage Constant Current
Range S1 S2 S1 S2
Amplitude end position
[1]
[1] Amplitude start position is fixed at 0 (V or A) by default.
0 V to 31.500 V 0 V to 8.400 V 0 A to 1.0500 A 0 A to 3.1500 A
Number of steps 1 step to 100 steps
Dwelling time 1 s to 99 s