Specifications

42
dataTec ▪ Ferdinand-Lassalle-Str. 52 ▪ 72770 Reutlingen ▪ Tel. 07121 / 51 50 50 ▪ Fax 07121 / 51 50 10 ▪ [e-mail] ▪ www.datatec.de
4242
16196C Parallel Electrode SMD
Test Fixture
Terminal Connector: 7 mm
DUT Connection: 2-Terminal
Electrical Length: 27.1 mm
Dimensions (approx.): 140(W) x 48(H) x 78(D) [mm]
Weight (approx.): 250 g
Additional Error:
f: frequency [GHz]
Up to 3 GHz (7 mm) SMD
Description: This test fixture is designed for impedance evaluations
of parallel electrode SMDs. It achieves stable frequency characteris-
tics up to 3 GHz and provides highly repeatable measurements. The
applicable SMD size code is 0201 (inch)/0603 (mm).
Applicable Instrument: 4287A*E4982A4294A42942AE5061B-3L5
with Opt. E5061B-005 + 16201A, E4991A
henusedwith16085B*4263B4268A*4279A*4284A*4285A
4288A*E4980AE4981A
*denotestheinstrumentisobsolete.
Frequency: DC to 3 GHz
Maximum Voltage: ±42 V peak max. (AC +DC)
Operating Temperature: -55°C to +85°C
DUT size: The applicable SMD size is 0201 (inch)/0603 (mm). For
details, see the figure below.
The 16196C is furnished with one insulator assembly. See the table
below for the dimensions of the insulator assembly.
Furnished Accessories:
Options:
16196C-710: Add the magnifying lens and tweezers
To maintain adequate measurement performance, keep the elec-
trodes and the short plate in good condition. Contaminants and
abrasion on these parts considerably affect measurement results,
especially for low value measurements. Periodic fixture cleaning and
part replacement is recommended to avoid deterioration of measure-
ment performance. The 16196x fixtures are designed with simplicity
in mind, so that an operator can easily replace parts. Spare parts,
which are likely to be abraded, are supplied with the 16196U
Maintenance Kit.
DUT Dimensions
1: Opt. 16196C-710 only
Type of Error Impedance
Proportional Error 1.0 x f
2
[%]
Open Repeatability 5 + 40 x f [
µS]
Short Repeatability 30 + 125 x f [mΩ]
Description P/N Qty.
Operation and Service Manual 16196-90040 1
Insulator Assembly Φ 0.48 mm 16196-60312 1
Open Plate 16196-29002 1
Short Plate 16196-29028 1
Push Ring 16196-24004 1
Magnifying Lens
1
16193-60002 1
Tweezers
1
8710-2081 1
Wrench 8710-0909 1
Cleaning Rod 5182-7586 1
Carrying Case 16196-60350 1
Hole Diameter of Insulator
assembly (mm)
SMD case size examples
Length, Width, Height (mm)
16196C Φ 0.48 0.6 x 0.3 x 0.3