Specifications
32
dataTec ▪ Ferdinand-Lassalle-Str. 52 ▪ 72770 Reutlingen ▪ Tel. 07121 / 51 50 50 ▪ Fax 07121 / 51 50 10 ▪ info@datatec.de ▪ www.datatec.de
3232
16092A Spring Clip Fixture
Terminal Connector: 7 mm
DUT Connection: 2-Terminal
Electrical Length: 3.4 mm
Dimensions (approx.): 150(W) x 70(H) x 80(D) [mm]
Weight (approx.): 180 g
Additional Error: See figure below
Up to 3 GHz (7 mm) Lead Components
Description: This test fixture is designed for impedance evaluation
of both lead and SMD. It is furnished with two modules that can be
readily screwed onto the plate to measure either lead or SMD.
Applicable Instrument: 4294A 42942A 4291B* 4287A* E4982A
E5051B-3L5withpt.E5061B-00516201AE4991A**
hen used with 16085B* 4263B 4268A* 4279A* 4284A* 4285A
4288A*E4980AE4981A
*denotestheinstrumentisobsolete.
**applicableinalimitedreuencyrange.
Frequency: DC to 500 MHz
Maximum Voltage: ±42 V peak max. (AC+DC)
Operating Temperature: 0°C to 55°C
DUT Size: See figure below
Furnished Accessories:
Compensation and Measurement: Open and short compensations
are recommended in combination with the electrical length compen-
sation before measurement. The fixture’s electrical length must be
entered into the electrical length compensation function of the mea-
surement instrument first. When using the SMD module, open com-
pensation is performed by separating the high and the low elec-
trodes from each other. The separation should be equivalent in size
to the DUT’s width. Short compensation is performed by usinf the
furnished shorting plate. When using the lead component module,
open compensation is performed by not having the module-elec-
trodes be connected to anything. Short compensation is performed
by using the furnished shorting plate. After performing open and
short compensations in combination with the electrical length com-
pensation, the DUT is inserted into the test fixture.
Inserting the SMD
Inserting the leaded component
DUT Dimensions
Description P/N Qty.
Shorting Plate 16092-08010 1
Operating Note 16092-90010 1