Specifications

17
dataTec ▪ Ferdinand-Lassalle-Str. 52 ▪ 72770 Reutlingen ▪ Tel. 07121 / 51 50 50 ▪ Fax 07121 / 51 50 10 ▪ [e-mail] ▪ www.datatec.de
17
16334A Tweezers Contact
Test Fixture
Terminal Connector: 4-Terminal Pair, BNC
DUT Connection: 2-Terminal
Cable Length (approx.): 1m (from BNC connectors
to the top of tweezers)
Weight (approx.): 290 g
Additional Error:
f: [MHz]
17
Up to 110 MHz (4-Terminal Pair) SMD
Description: This test fixture is designed for impedance evaluations
of SMD. The minimum SMD size that this fixture is adapted to evalu-
ate is 1.6(L) x 0.8(W) [mm]. The tweezers’ contacts on this fixture
makes it easy to hold the DUT.
Applicable Instruments:4263B4268A*4279A*4284A*4288A*
E4980AE4981A4285A4294A**
*denotestheinstrumentisobsolete.
**applicableinalimitedreuencyrange.
Frequency: 5 Hz to 15 MHz
Maximum Voltage: ±42 V peak max. (AC+DC)
Operating Temperature: 0°C to 55°C
DUT Size: ≤10 mm (width)
See figure below
Furnished Accessories:
Compensation and Measurement: Open and short compensations
are recommended before measurement. Open and short compensa-
tions are performed by using the furnished compensation block.
After performing open and short compensations, the DUT is sand-
wiched by the tweezers’ contacts and is measured.
DUT Dimensions
Description P/N Qty.
Compensation Block 16334-60001 1
Operating Note 16334-90000 1
Type of Error Impedance
Proportional Error ±2 x (f/10)
2