Specifications
14
dataTec ▪ Ferdinand-Lassalle-Str. 52 ▪ 72770 Reutlingen ▪ Tel. 07121 / 51 50 50 ▪ Fax 07121 / 51 50 10 ▪ info@datatec.de ▪ www.datatec.de
14
16034H Test Fixture
Terminal Connector: 4-Terminal Pair, BNC
DUT Connection: 2-Terminal
Dimensions (approx.):
120(W) x 50(H) x 70(D) [mm]
Weight (approx.): 200 g
Additional Error:
f: [MHz]
14
Up to 110 MHz (4-Terminal Pair) SMD
Description: This test fixture is designed for impedance evaluations
of array-type SMD. The minimum SMD size that this fixture is
adapted to evaluate is 1.6(L) x 0.8(W) [mm]. Since the tip of the
measurement electrodes are very thin and the device holder is
extremely flat, the device can be shifted and the measurement
electrodes can contact the each elements of the array-type
component.
Applicable Instruments:4263B4268A*4279A*4284A*4285A
4288A*4294AE4980AE4981AE5061B-3L5withpt.E5061B-005
*denotestheinstrumentisobsolete.
Frequency: DC to 110 MHz
Maximum Voltage: ±42 V peak max. (AC+DC)
Operating Temperature: 0°C to 55°C
DUT Size: See figure below
Furnished Accessories:
Compensation and Measurement: Open and short compensations
are recommended before measurement. When measuring above 3
MHz, load compensation is also recommended. Open compensation
is performed by separating the high and the low electrodes from
each other. The separation should be equivalent in size to the DUT’s
width. Short compensation is performed by placing the high and low
electrodes in contact together. Load compensation is performed by
using the furnished 100 Ω SMD chip resistor. After performing open,
short and load compensations, the DUT is inserted into the test fix-
ture. Refer to the 16034G figures to see how compensation and
measurement are performed.
DUT Dimensions
Electrode dimensions
Description P/N Qty.
Case for 100 Ω SMD Resistance 1540-0692 1
100Ω Chip Resistor 0699-2488 10
Operating Manual 16034-90012 1
Type of Error Impedance
Proportional Error 0.5 x (f/10)
2
[%]
Open Repeatability 5 + 500 x (f/10) [nS]
Short Repeatablity 10 + 13 x (f/10) [mΩ]