User`s manual

EPC7-7 : Where To Go Next
So far you should have done the following:
• Configured the Agilent RADI-EPC7 as a Slot 0 (or Non-Slot 0 for
multiple mainframes) Device
• Installed the EPC7 into the mainframe
• Installed EXM expansion modules
• Installed the Command Module (optional)
• Connected cables
• Applied power and verified installation
Once you have completed this procedure, continue with one of the
following procedures:
If you have multiple mainframes connected via MXIbus:
• "Procedure 3: Set Up Your System for Multiple Mainframes"
If you are using one mainframe:
• "Procedure 4: Configure and Install Instruments"
C-Size Configuration Guide Setting Up an Embedded RADI-EPC7 Computer 2-63