User`s manual

EPC7-4C : Set the Command Module’s Primary GPIB Address
Register-based modules in the servant area of the Command Module are
accessed from the EPC7 across GPIB and through the Agilent E1406A
Command Module. The primary GPIB address identifies the GPIB port on
the Command Module. This address is combined with the Command
Module’s secondary GPIB address (always 00), and with the EPC7
computer’s (GPIB) interface select code (typically 7), to form the
Command Module’s complete GPIB address.
E1406A
GPIB Address Switch
GPIB
Figure 2-45. Setting the E1406A Primary GPIB Address
2-58 Setting Up an Embedded RADI-EPC7 Computer C-Size Configuration Guide