User`s manual

EPC7-3 : Install EXM Expansion Modules
EXM expansion modules are used for video controllers, network interfaces,
and GPIB interfaces. Some EXM modules come already installed.
However, if you have an EXM module that needs to be installed, use the
following procedure:
1. Turn off mainframe power by pressing the button at the bottom left
corner of the mainframe.
2. Slide the EXM module into place in the card guides.
3. Push firmly on the EXM module front panel to insert its rear
connector.
4. Tighten the thumb screws on the EXM’s faceplate.
NOTE When inserting a EXM module, avoid touching the circuit board and make
sure you are operating in a static-free environment.
Slide the EXM Module into the EPC7
expansion slot until it inserts into the
rear connector
Figure 2-42. Installing an EXM Module
2-54 Setting Up an Embedded RADI-EPC7 Computer C-Size Configuration Guide