User`s manual

EPC7-1A : Set the EPC7 as Non-Slot 0 Device if Using Multiple
Mainframes
If you are using multiple mainframes connected via MXIbus, the EPC7
Embedded Computer must be set as a Non-Slot 0 device. Therefore, you
must change the following jumpers.
NOTE Once the EPC7 is configured as a non-slot 0 device, it must NOT be
installed in slot 0.
Install jumpers to set EPC7
as Non-Slot 0 Device
Figure 2-40. Setting EPC7 as Non-Slot 0 Device
C-Size Configuration Guide Setting Up an Embedded RADI-EPC7 Computer 2-51