User`s manual

EPC7-1 : Set the EPC7 as Slot 0 Device
The Agilent RADI-EPC7 is shipped from the factory to be the VXI Slot 0
Controller and System Controller. Therefore, if you are using the EPC7 as
the slot 0 controller, you do not have to change any switches or jumpers.
This figure illustrates the jumper positions and definitions.
Slot 0 functionality is used during operation for the following purposes:
– locate where modules are installed in the mainframe.
– manage data flow across the VXIbus backplane busses
– provide the system clock (SYSCLK - 16 MHz)
See Appendix A, "Terms and Definitions," for additional information on the
slot 0 device. See the Agilent RADI-EPC7 documentation for information
on other EPC7 Configurations.
NOTE Once the EPC7 is set as the slot 0 device, it must then be installed in slots 0
and 1 of the mainframe.
Jumpers installed to set
EPC7 as Slot 0 Controller
and System Controller
Figure 2-39. Setting EPC7 for Slot 0 Controller
2-50 Setting Up an Embedded RADI-EPC7 Computer C-Size Configuration Guide