User`s manual

Setting Up an Embedded RADI-EPC7 486 Computer
This procedure explains how to set up and install an Agilent 75000 Series C
VXIbus system equipped with an Embedded Agilent RADI-EPC7
Computer. The steps in this procedure consists of the following:
• EPC7-1 : Set the EPC7 as Slot 0 Device
• EPC7-1A : Set the EPC7 as Non-Slot 0 Device if Using Multiple
Mainframes
• EPC7-2 : Install the EPC7 into the Mainframe
• EPC7-3 : Install EXM Expansion Modules
• EPC7-4 : Configure the Command Module to Work With the EPC7
• EPC7-5 : Connect Interface Cables
• EPC7-6 : Apply Power
• EPC7-7 : Where To Go Next
The embedded Agilent RADI-EPC7 computer is shipped from the factory
with software already installed. EPConnect is a set of system development
tools that can be used on the VXIbus system containing one or more Agilent
RADI-EPC modules. One of the tools is the Start-Up Resource Manager
(SURM). The SURM performs the required functions of the resource
manager.
If you need information on terms used in this manual, see Appendix A,
"Terms and Definitions."
CAUTION STATIC ELECTRICITY. Static electricity is a major cause of
component failure. To prevent damage to the electrical
components in the mainframe and plug-in modules, observe
anti-static techniques whenever handling a module.
NOTE The EPC7 contains a hard disk. Please handle it with care. Avoid jarring
the unit while it is in operation, and do not use excessive force when
inserting or removing the EPC7 in a VXIbus mainframe.
C-Size Configuration Guide Setting Up an Embedded RADI-EPC7 Computer 2-49