User`s manual

V743-3 : Install the V743 Controller in the Mainframe
Use the following procedure to install the V743 controller into mainframe
slot 0.
1. If the mainframe is on, turn it off.
2. Insert the V743 into the mainframe by aligning the top and bottom
of the controller with the card guides inside the mainframe. Slowly
push the V743 into slot 0 until it seats in the backplane connectors.
3. Tighten the retaining screws on the top and bottom of the
controller’s front panel.
Note If your system contains an Agilent E1406A Command Module, continue
through step V743-3. Otherwise, continue with step V743-4.
Note For information on connecting the monitor, keyboard, mouse, and external
peripherals, refer to the "Model V743 VXI Controller Installation Guide".
Step V743-4 of this procedure assumes that a keyboard and monitor have
been connected.
2-42 Setting Up an Embedded V743 Controller C-Size Configuration Guide