User`s manual

V743-2C : Setting
the Command
Module Primary
GPIB Address
Register-based modules in the servant area of the Command Module are
accessed from the V743 across GPIB and through the Agilent E1406A
Command Module. The primary GPIB address identifies the GPIB port on
the Command Module. This address is combined with the Command
Module’s secondary GPIB address (always 00), and with the V743
controller’s (GPIB) interface select code (typically 7), to form the
Command Module’s complete GPIB address.
The location of the primary GPIB address switch is shown in Figure 2-34.
E1406A
Primary GPIB Address
Switch location
Figure 2-34. Setting the E1406A Primary GPIB Address
2-40 Setting Up an Embedded V743 Controller C-Size Configuration Guide