User`s manual

Series 700-3 : Install the Agilent E1482B Extender Module in the
Mainframe
Use the following procedure to install the Agilent E1482B VXIbus
Extender Module into mainframe slot 0.
1. If the mainframe is on, turn it off.
2. Insert the module into the mainframe by aligning the top and
bottom of the VXIbus extender module with the card guides inside
the mainframe. Slowly push the module into slot 0 until it seats in
the backplane connector.
3. Tighten the retaining screws on the top and bottom edges of the
module’s front panel.
Installing the
E1406A Command
Module
Use the following procedure to install the Agilent E1406A Command
Module into slot 1 (when the Agilent E1482B module is installed in slot 0).
1. If the mainframe is on, turn it off.
2. Insert the Command Module into the mainframe by aligning the top
and bottom of the card with the card guides inside the mainframe.
Slowly push the module straight into the slot until it seats in the
backplane connectors. The front panel of the module should be
even with the front panel of the mainframe.
3. Tighten the retaining screws on the top and bottom edges of the
Command Module front panel.
2-28 Setting Up a Series 700 Computer C-Size Configuration Guide