User`s manual

E1406-11 : Where To Go Next
So far you should have done the following:
• Configured your Agilent E1406A Command Module for operation
with an external computer (PC or Workstation)
• Installed the Command Module into the Mainframe
• Connected Interface Cables
• Applied Power and verified operation
Once you are done with this procedure, continue with one of the following
procedures:
If you have multiple mainframes connected via MXIbus:
• "Procedure 3: Set Up Your System for Multiple Mainframes"
If you are using one mainframe:
• "Procedure 4: Configure and Install Instruments"
C-Size Configuration Guide Setting Up the E1406 Command Module 2-17