User`s manual

E1406-8 : Install the Command Module into the Mainframe
Use the following procedure to install the Agilent E1406A Command
Module into slot 0.
1. Turn off power on the mainframe by pressing the power button in
the lower left corner.
2. If the modules will be installed into a D-Size mainframe, install a
support designed for installing C-Size cards in D-Size mainframes.
3. Insert the module into the mainframe by aligning the top and bottom
of the card with the card guides inside the mainframe. Slowly push
the module straight into the slot until it touches the backplane
connectors.
4. Push in the extraction levers to seat the module into the mainframe.
5. Tighten the retaining screws on the top and bottom edges of the
front panel.
Backplane
Connectors
Tighten 2
Screws
Slide Module into the
Mainframe until it touches
the Backplane Connectors
Extraction
Levers
Figure 2-10. Installing Modules
2-10 Setting Up the E1406 Command Module C-Size Configuration Guide