User`s manual

Index
C-Size VXIbus Configuration Guide
A
A-size modules, installing, 4-8
Address
description, Command Module GPIB, A-7
setting on B- and C-size modules, 4-4
setting on the Command Module, 2-9
setting VXI-MXI module, 3-10
Address Windows
description, A-8
Address, Command Module GPIB, 2-25, 2-40
Addressing instruments from an embedded computer,
6-3
Addressing instruments over GPIB, 6-2
Addressing instruments using C-SCPI, 6-5
Addressing instruments using SICL, 6-4
Allocating shared RAM, 2-7
description, A-4
Alternate Command Module configurations, 2-15
Applying power
GPIB interface with external computer, 5-1
MXIbus interface with Series 700 computer, 5-4
VXI interface with embedded Agilent RADI-EPC7
computer, 5-9
VXI interface with embedded V743 controller, 5-7
Agilent RADI EPC7 embedded computer, 2-61
GPIB interface with external computer, 2-13
Applying power, mainframe, 5-1
Arbitration, data transfer bus, A-3
Assigning interrupt lines, 2-32, A-12
V743 controller, 2-47
B
B-size modules, installing, 4-8
Backplane connector shields, 4-15
Bus request level
description, A-3
setting on Command Module, 2-6
C
C-SCPI programming, 6-5
C-size modules, installing, 4-11
Certification, 5
Chassis shield, 4-14
CLK10
description, Command Module, A-3
setting on the Command Module , 2-5
Command Module
10 MHz clock source, 2-5, A-3
allocating shared RAM, 2-7
alternate configurations, 2-15
bus request level description, A-3
disabling slot 0 capability, 2-26, 2-41
primary address description, A-7
primary GPIB address, 2-25, 2-40
resource manager description, A-2
servant area description, A-5
setting bus request level, 2-6
setting GPIB address, 2-9
setting resource manager, 2-3
setting servant area , 2-8
setting slot 0 device, 2-4
slot 0 description, A-2
V743 embedded controller configuration, 2-37
Command Module, installing with a V743, 2-44
Commands
SCPI structure, 6-7
terminating, 6-8
Comment sheet, reader, 1-7
Computer and VXI mainframe interface, 2-18
Configuration and start-up errors, 1-1
Configure the VXI mainframe, 1-1
Configuring RS-232
Command Module, 2-12
Connecting a display terminal
Command Module, 2-11
Agilent RADI EPC7, 2-60
Connecting interface cables
Command Module, 2-11
Agilent RADI EPC7, 2-60
VXI-MXI Modules with multiple mainframes, 3-24
Connecting power cords, 1-3
Controller and VXI mainframe interface
V743 Embedded Controller, 2-35
Coupled Commands
Executing, 6-12
C-Size VXIbus Configuration Guide Index 1