User`s manual

Error Message Cause
38 INVALID UDEF CNFG TABLE DATA There are 0, or greater than 254 entries in the user-defined
commander/servant hierarchy table.
39 INVALID UDEF DC TABLE The valid flag in the user-defined dynamic configuration
table is not true (1). VXI:CONF:DCT <address> has been
set but is pointing to an invalid table. Either the table is
corrupt or has not been downloaded.
40 INVALID UDEF DC TABLE DATA There are 0, or greater than 254 entries in the user-defined
dynamic configuration table.
41 INVALID UDEF INTR TABLE The valid flag in the user-defined interrupt line allocation
table is not true (1). VXI:CONF:ITAB <address> has been
set but is pointing to an invalid table. Either the table is
corrupt or has not been downloaded.
42 INVALID UDEF INTR TABLE DATA The interrupt line allocation table has invalid data. The
number of records is less than 1 or greater than 7, the
interrupt line specified is less than 1 or greater than 7, or the
number of interrupters or handler ID is less than 1 or greater
than 254.
43 INVALID UDEF MEM TABLE The valid flag in the user-defined A24/A32 address
allocation table is not true (1). VXI:CONF:MTAB <address>
has been set but is pointing to an invalid table. Either the
table is corrupt or has not been downloaded.
44 INVALID UDEF MEM TABLE DATA An invalid logical address was specified in the A24/A32
address allocation table. The logical address range is 0 to
255 or -1.
WARNING NVRAM CONTENTS LOST System non-volatile memory was cleared during a re-boot.
DIAG:BOOT:COLD was executed or the memory had a
invalid checksum.
46 MESG BASED OPEN ACCESS FAILED IBASIC or GPIB access to a message-based device failed
because of a device failure. The resource manager tries to
open a paths between the GPIB port and/or IBASIC and
message-based devices (I and I4) using word serial
commands. The device either failed to respond, or the
device violates the VXI word serial protocol specification.
47 GRANTED DEVICE NOT FOUND The Command Module, when not the resource manager,
was granted a device that does not exist.
WARNING DRAM CONTENTS LOST Downloaded driver non-volatile memory was cleared during
a re-boot. DIAG:BOOT:COLD was executed or the memory
had a invalid checksum.
49 VME SYSTEM CONTROLLER
DISABLED
The System Controller switch on the Command Module is
set to the ’Disable’ position.
50 EXTENDER NOT SLOT 0 DEVICE A VXI-MXI mainframe extender module is not in slot 0 of its
(remote) mainframe.
51 INVALID EXTENDER LADD WINDOW Modules do not fit in the logical address window set by the
user-defined extender table. Not all of the devices found
"below" an extender will fit into the largest available window
for that extender. Either reset the logical addresses or use
the extender table to override the default algorithm.
Table 1. Command Module Resource Manager Configuration Errors (Cont’d)
C-Size Configuration Guide Configuration and Start-up Errors B-5