User`s manual

Procedure 1:
Configure the VXI Mainframe
This procedure describes how to configure the Agilent E1401B and Agilent
E1421B VXI mainframes in preparation for installing modules and applying
power. This procedure consists of the following steps:
• Connect mainframe safety ground (if necessary)
• Connect the power cord
Once you have completed the applicable steps in this procedure, continue
with the next procedure, "Procedure 2 : Set Up the VXI System
Controller."
WARNING SHOCK HAZARD. Only service-trained personnel who are
aware of the hazards involved should install, remove, or
configure the system. Before you perform any procedures,
disconnect AC power and field wiring from the mainframe.
CAUTION STATIC ELECTRICITY. Static electricity is a major cause of
component failure. To prevent damage to the electrical
components in the mainframe and plug-in modules, use
anti-static techniques whenever handling a module.
1-1 Configure the VXI Mainframe C-Size Configuration Guide