User`s manual

Procedure 4:
Configure and Install Instruments
This procedure describes how to configure and install VXI modules into
your Agilent 75000 Series C VXIbus System. The procedure consists of the
following steps:
• Step-1 : Download Instrument Drivers
• Step-2 : Set Instrument Logical Addresses
• Step-3 : Install A- and B-Size Modules With a Module Carrier
• Step-4 : Install C-Size Modules
• Step-5 : Install a Chassis Shield
• Step-6 : Install Backplane Connector Shields
• Step-7 : Install Faceplate Panels
• Step-8 : Where To Go Next
WARNING SHOCK HAZARD. Only service-trained personnel who are aware
of the hazards involved should install, remove, or configure the
system. Before you perform any procedures in this guide,
disconnect AC power and field wiring from the mainframe.
To avoid electrical shock, always cover unused slots with the
faceplate panels that came with the mainframe.
CAUTION STATIC ELECTRICITY. Static electricity is a major cause of
component failure. To prevent damage to the electrical
components in the mainframe and plug-in modules, observe
anti-static techniques whenever handling a module.
C-Size Configuration Guide Configure and Install Instruments 4-1