User`s manual

MXIbus-8 : Apply Power
Once you have installed your MXIbus system, you can apply power by
pressing the button in the lower left corner of the mainframe. There are
several ways you can confirm installation. However, the method used
depends on what type of system controller you are using.
Turn the mainframe’s power on and check the system configuration with
the examples shown in Procedure 5 : Apply Power later in this guide.
Confirm installation by checking the card address and slot location.
MXIbus-9 : Where To Go Next
So far you should have done the following:
• Set up the VXI-MXI modules for slot 0 and non-slot 0 operation
• Removed terminating networks from the middle VXI-MXI modules
• Set the VXI-MXI module logical address
• Disable VMEbus Timeout on other devices
• Installed the VXI-MXI Modules
• Connected Interface Cables
• Applied Power and confirmed installation
Once you have completed these steps, continue with the following
procedure:
• "Procedure 4: Configure and Install Instruments"
C-Size Configuration Guide Set Up the System for Multiple Mainframes 3-25