User`s manual

Jumper Wire and
Contacts
A crimp-and-insert contact is crimped onto each end of a single conductor
jumper wire. This jumper is typically used to tie two pins together in a
single crimp-and-insert connector. Order Agilent 91512A.
Crimp-and-Insert
Contacts
These contacts may be crimped onto a conductor and then inserted into a
crimp-and-insert connector. The crimp tool kit is required to crimp the
contacts onto a conductor and remove the contact from the connector.
Order Agilent 91515A.
Crimp-and-Insert Tools The hand crimp tool (part number Agilent 91518A) is used for crimping
contacts onto a conductor. The pin extractor tool (part number Agilent
91519A) is required for removing contacts from the crimp-and-insert
connector. These products are not included with Option A3E or with the
terminal option accessories listed earlier.
Extra Crimp-and-Insert
Connectors
The crimp-and-insert connector is normally supplied with Option A3E.
Contact Agilent Technologies if additional connectors are needed. Order
Agilent 91484B.
Length: 10 cm
Wire Gauge: 24 AWG
Quantity: 10 each
Insulation Rating: 105°C maximum
Voltage: 300 V
Quantity: 250 each
Wire Gauge Range: 20 - 26 AWG
Plating: Gold Plated Contact
Maximum Current: 2A at 70°C
28 Configuring the Agilent E1490C Chapter 2