User`s manual

Terminal Module
Option A3E
Option A3E can be ordered if a crimp-and-insert terminal module is desired.
This allows you to crimp connectors onto wires which are then inserted
directly into the breadboard’s mating connector. Refer to the schematics in
Appendix B to make the connections.
Crimp-and-Insert
Terminal Module
Accessories
The following accessories are necessary for use with crimp-and-insert
Option A3E:
Single-Conductor and
Contact
A crimp-and-insert contact is crimped onto one end of a wire. The other
end is not terminated. Order Agilent 91510A.
Shielded-Twisted-Pair
and Contacts
A crimp-and-insert contact is crimped onto each conductor at one end of a
shielded-twisted-pair cable. The other end is not terminated. Order Agilent
91511A.
Figure 2-16. Crimp-and-Insert Connector
Length: 2 meters
Wire Gauge: 24 AWG
Quantity: 50 each
Insulation Rating: 105°C maximum
Voltage: 300 V
Length: 2 meters
Wire Gauge: 24 AWG
Outside Diameter: 0.1 inch
Quantity: 25 each
Insulation Rating: 250°C maximum
Voltage: 600 V
Chapter 2 Configuring the Agilent E1490C 27