User`s manual

Terminal Modules
The Agilent E1490C Breadboard Module is comprised of a component PC
board and a screw-type standard terminal module. If the screw-type terminal
module is not desired, a crimp-and-insert terminal module (Option A3E) is
available. See page 27 for information about the crimp-and-insert option and
accessories.
Note Refer to pages 29 and 30 before attempting to wire the terminal module.
Screw-type
Terminal Module
Figure 2-15 shows the breadboard’s standard screw-type terminal module
connectors. Use the following guidelines for wire connections.
Wiring Guidelines
• Be sure that wires make good connections on screw terminals.
• Maximum terminal wire size is No. 16 AWG. Wire ends should be
stripped 6 mm (
≈ 0.25 inch) and tinned to prevent single strands from
shorting to adjacent terminals.
Figure 2-15. Agilent E1490C Standard Screw-type Terminal Module
26 Configuring the Agilent E1490C Chapter 2