User`s manual

Installing the Breadboard in a Mainframe
Refer to Figure 2-14 to install the breadboard in a mainframe.
Set the extraction levers out.
Slide the Agilent E1490C into any slot
(except slot 0) until the backplane
connectors touch.
Seat the breadboard into the
mainframe by pushing in the
extraction levers.
Tighten the top and bottom screws to
secure the breadboard module to the
mainframe.
To remove the breadboard from the mainframe,
reverse the procedure.
NOTE: The extraction levers will
not seat the backplane connectors
on older VXIbus mainframes. You
must manually seat the connectors
by pushing in the module until the
module’s front panel is flush with
the front of the mainframe. The
extraction levers may be used to
guide or remove the breadboard.
Figure 2-14. Installing the Breadboard in a VXIbus Mainframe
Chapter 2 Configuring the Agilent E1490C 25