User`s manual

Agilent E1490C
Hardware Features
An overview of the Agilent E1490C hardware features follows.
• Connectors. A 96-pin DIN connector connects to the terminal
module. Crimp-and-Insert terminal module connectors are available
with Option A3E.
• Component Area. An area of approximately 460 cm
2
(72 inches
2
)
is available on the module to install your own custom circuitry. This
area does not include the portion of the circuit board required by the
backplane interface components.
• Component Height/Lead Length. The maximum component
height allowed above the circuit board is 18.0 mm (0.71 inch).
The maximum component lead length allowed below the circuit
board is 3.2 mm (0.125 inch).
WARNING Since inputs to the Agilent E1490C Breadboard Module are
through a 96-pin DIN connector and a terminal module
assembly, limit voltage to 250 Vdc/250 Vrms.
Chapter 1 Introduction 11