Technical data

3- 30 Agilent 41000 Administration Guide, Edition 3
Using Agilent iPACE Verification Tool
Reading Result Data
Reading Result Data
This section explains the contents of the result data displayed on the ‘Result Window’ area
of the ‘iPACE Verification Tool’ window. The parameters covered by [ ] are optional.
The data will be logged into the log file. In the log file, the parameters are separated by tab.
• Self-test:
Model Result
• Connection check:
Source Input Slot Output Judge
• Connection check (batch mode):
Source Input Slot Output
Unit MInput MSlot MOutput VMeasure Status Time
• Noise offset measurement:
Source Input Slot Output IMeasure Status Time
:
Source Input Slot Output IOffset Noise
50 data lines will be listed between the above lines.
• Settling time/leakage current measurement:
Source Input Slot Output IMeasure Status Time
:
Source Input Slot Output ILeak VStep
Data lines for 100 seconds measurement will be listed between the above lines.
NOTE Default Log File
In the default setting, the data will be logged into the following file.
folder: <installed folder>/bin
file name: iPACE Verification Tool (Report).txt
To change the log file, use the Open Report File dialog box opened by clicking
File
> Open Report File. After changing the file name, the result data will be logged into
the new file.