Technical data
Agilent 41000 Administration Guide, Edition 3 2- 3
Installation and Operation
Installation
Installation
This section provides the information and the procedures needed to install the Agilent
41000.
• “Before Installation”
• “Inspection”
• “Model 100: To Connect ASU”
• “Model 100/200: To Connect 16495”
• “Model 100/200: To Make Your Connector Panel”
• “Model 300/400: To Install B2220A”
• “Model 300/400: To Use Test Fixture”
• “Model 300/400: To Connect Measurement Cables”
• “To Connect Power Cable”
• “To Connect GPIB Cable”
• “To Check Operation”
Before Installation
Before starting the installation, secure enough space to install the Agilent 41000 and
prepare the site power line and the receptacle for the Agilent 41000 power cable. Also
arrange the installation of the auto prober if necessary. For details, see Agilent
41000
Preinstallation Guide.
Inspection
When you open the box that contains the Agilent 41000, check the following:
1. Before unpacking any components, inspect all boxes for any signs of damage that
might have occurred during shipment such as:
•Dents
• Scratches
•Cuts
• Water marks
2. When you open the boxes that contain the Agilent 41000, check the components
against the contents lists that are attached to the boxes.
If anything is wrong, notify your local Agilent Technologies sales office.