Technical data
Agilent 41000 Administration Guide, Edition 3 7- 27
Service
Replacement Procedure
To Replace Probe Card Interface Cables
1. Open the zipper tube.
2. Disconnect and remove the defective cables.
3. Connect and reinstall the new cables instead of the defective cables.
4. Wrap the all measurement cables by using the zipper tube, and close it completely.
Then use the Tool Zip Lock Sealing (Agilent part number 8710-1576).
Figure 7-17 Replacing Probe Card Interface Cables
6QQN<KR.QEM5GCNKPI
#IKNGPV20