Manualshelf

Technical data

ManualsBrandsAgilent Technologies ManualsComputer AccessoriesB2201A
171172173174175176177178179180
Agilent 41000 Administration Guide, Edition 3 7- 25
Service
Replacement Procedure
To Remove PDU
1. Set the main switch on the power distribution unit (PDU) to the OFF position.
2. Disconnect the PDU system power cable from the power outlet of the installation site.
3. Disconnect the EMO cable from the rear side of the PDU.
4. Remove the power cables of instruments from the rear side of the PDU.
5. Remove screw that fastens the ground wire to the PDU. Then use a plus screwdriver
(H2).
6. Remove dress screws that fix the PDU with flanges to the system cabinet. Then use a
plus screwdriver (H2).
7. Slide the PDU to the front side a little.
8. Remove screws that fix the flange to the PDU, and remove the flanges at the both left
side and right side. Then use the plus screwdriver (H2).
9. Slide the PDU to the front side, and remove the PDU from the system cabinet.
Figure 7-15 Removing PDU