Technical data
Agilent 41000 Administration Guide, Edition 3 7- 23
Service
Replacement Procedure
To Remove Instruments
1. Remove the power cable and the GPIB cable from the instrument at the rear side.
2. Remove the test leads or cable assemblies from the instrument at the front side.
3. Remove dress screws that fix the instrument with flanges to the system cabinet. Then
use a plus screwdriver (H2).
4. Slide the instrument to the front side a little, as shown in Figure 7-13.
5. Remove screws that fix the flange to the instrument, and remove the flanges at the both
left side and right side. Then use the plus screwdriver (H2).
6. Slide the instrument to the front side, and remove the instrument from the system
cabinet.
Figure 7-13 Removing Instrument
5ETGYJQNG
5[UVGOECDKPGV
(NCPIG +PUVTWOGPV