Technical data

Agilent 41000 Administration Guide, Edition 3 7- 19
Service
Replacement Procedure
Safety Considerations
Before servicing is started, turn off the Agilent 41000. For the procedure, see “Turning the
PDU On and Off” on page 2-24.
WARNING Turn OFF the power distribution unit (PDU) before starting service. Do not turn on
the PDU while accessing internal components of the cabinet or until the replacement
parts are reinstalled. Dangerous voltage may be applied to several terminals.
WARNING To ensure the safety during service, set the PDU main switch to the OFF position.
WARNING Be aware of the hazards involved while replacing procedure.
After repairs are completed, make sure all safety features are intact and are
functioning properly, and that all necessary parts are connected to their protective
grounds.
WARNING Remove or reinstall the system component carefully with an assistant and a lifter to
prevent from injury.
The 4155C/4156C/41501B/4284A should be removed or reinstalled by two persons.
The E5270B/B2200A/B2201A should be removed or reinstalled by two persons using
a lifter.
The PDU can be removed or reinstalled by one person.