Technical data

Agilent 41000 Administration Guide, Edition 3 7- 3

Service

Troubleshooting

This section gives troubleshooting and repair information for the Agilent 41000, and

contains the following sections:

• “Safety Considerations”

• “Checking Power Distribution Unit (PDU)”

• “Troubleshooting”

A troubleshooting overview for the Agilent 41000 is shown below.

1. If the Agilent 41000 loses power:

Check the operation of the power distribution unit (PDU) and the emergency off

(EMO) panel.

See “Checking Power Distribution Unit (PDU)” on page 7-4.

2. If you have trouble with the Agilent 41000 system:

Check the Agilent 41000 system by using the Agilent iPACE Verification Tool.

See “Using Agilent iPACE Verification Tool” on page 3-1.

After troubleshooting, repair the Agilent 41000 by replacing the defective part of the

system. For the replacement procedures, see

“Replacement Procedure” on page 7-18.

NOTE Several troubleshooting procedures described in this chapter require access to several

components/assemblies in the Agilent 41000 system cabinet. For the location of

components and assemblies, see “Replaceable Parts” on page 7-11.