User`s guide
Table Of Contents
- User’s Guide
- 1 Getting Started
- 2 Introduction
- 3 Installation
- 4 Using EasyEXPERT
- 5 Classic Test Definition
- I/V Sweep
- Multi Channel I/V Sweep
- I/V List Sweep
- I/V-t Sampling
- C-V Sweep
- Direct Control
- Function Setup
- Auto Analysis Setup
- Display Setup
- SMU Range Setup Window
- ADC and Integration Time Setup Window
- Advanced Setup Window
- CMU Range Setup Window
- Advanced Setup Window for C-V Sweep
- Switching Matrix Control
- SPGU Control
- SPGU Pulse Setup Window
- Load Z Setup Window
- Pulse Switch Setup Window
- SPGU ALWG Setup Window
- Define ALWG Waveform Window
- 6 Application Test Definition
- 7 Function Details
- I/V Sweep Measurement
- Multi Channel I/V Sweep Measurement
- I/V-t Sampling Measurement
- C-V Sweep Measurement
- SPGU Module
- Sweep Abort Function
- Standby Function
- Bias Hold Function
- Current Offset Cancel
- SMU CMU Unify Unit
- Atto Sense and Switch Unit
- SMU/PG Selector
- SMU Ranging Mode
- SMU Compliance
- SMU Pulse
- SMU Measurement Time
- SMU Filter
- SMU Series Resistor
- Interlock Function
- Auto Power Off Function
- Initial Settings
- 8 Built-in Programming Tool
- 9 If You Have a Problem
- When You Operate B1500A
- When You Perform Measurement
- Measurement Takes More Time than Specified
- Noise Affects the Measured Values
- Voltage Measurement Error is Large
- SMU Oscillates for High-Frequency Device Measurements
- SMU Oscillates for Negative Resistance Measurements
- Large Current Causes High Temperature (Thermal Drift)
- Measurement Damages the Device under Test
- Leaving Connections Damages Devices after Measurement
- Unexpected Sampling Measurement Data is Returned
- MFCMU Causes Unbalance Condition
- Before Shipping to Service Center
- Data Backup and Recovery
- B1500A System Recovery
- Updating EasyEXPERT
- Error Codes
- 10 Application Library and Utilities
Agilent B1500 User’s Guide, Edition 7 10-49
Application Library and Utilities
License Management Tool
License Management Tool
The licence management tool is the program used to install the license of the
Agilent B1540A-002 EasyEXPERT Plus edition or the Agilent B1541A-002
Desktop EasyEXPERT Plus edition. This program is also used to confirm the
licenses already installed and the host ID of the B1500A or the controller for
Desktop EasyEXPERT.
To launch program Click Start > All Programs > Agilent B1500A EasyEXPERT >
Licence Management Tool.
To check licenses
already installed
Click Installed Licenses tab on the Licence Management Tool. The installed
licenses will be displayed.
To check host ID Click Information tab on the Licence Management Tool. The host ID will be
displayed.
To install license The following procedure installs the license.
1. Click Install icon, or click File > Install License File to open a dialog box.
2. Specify the license file (.lic file) of the B1540A-002 or the B1541A-002.
3. Click Open.
License Management Tool GUI
File menu Install License File Opens a dialog box used to specify the license file.
Exit Closes the Licence Management Tool.
Help menu About Opens the About dialog box.
Install icon Opens a dialog box used to specify the license file.
Installed Licenses
tab screen
Displays the license already installed.
Information tab
screen
Displays the host ID of the B1500A or the controller for Desktop EasyEXPERT.