User`s guide
Table Of Contents
- User’s Guide
- 1 Getting Started
- 2 Introduction
- 3 Installation
- 4 Using EasyEXPERT
- 5 Classic Test Definition
- I/V Sweep
- Multi Channel I/V Sweep
- I/V List Sweep
- I/V-t Sampling
- C-V Sweep
- Direct Control
- Function Setup
- Auto Analysis Setup
- Display Setup
- SMU Range Setup Window
- ADC and Integration Time Setup Window
- Advanced Setup Window
- CMU Range Setup Window
- Advanced Setup Window for C-V Sweep
- Switching Matrix Control
- SPGU Control
- SPGU Pulse Setup Window
- Load Z Setup Window
- Pulse Switch Setup Window
- SPGU ALWG Setup Window
- Define ALWG Waveform Window
- 6 Application Test Definition
- 7 Function Details
- I/V Sweep Measurement
- Multi Channel I/V Sweep Measurement
- I/V-t Sampling Measurement
- C-V Sweep Measurement
- SPGU Module
- Sweep Abort Function
- Standby Function
- Bias Hold Function
- Current Offset Cancel
- SMU CMU Unify Unit
- Atto Sense and Switch Unit
- SMU/PG Selector
- SMU Ranging Mode
- SMU Compliance
- SMU Pulse
- SMU Measurement Time
- SMU Filter
- SMU Series Resistor
- Interlock Function
- Auto Power Off Function
- Initial Settings
- 8 Built-in Programming Tool
- 9 If You Have a Problem
- When You Operate B1500A
- When You Perform Measurement
- Measurement Takes More Time than Specified
- Noise Affects the Measured Values
- Voltage Measurement Error is Large
- SMU Oscillates for High-Frequency Device Measurements
- SMU Oscillates for Negative Resistance Measurements
- Large Current Causes High Temperature (Thermal Drift)
- Measurement Damages the Device under Test
- Leaving Connections Damages Devices after Measurement
- Unexpected Sampling Measurement Data is Returned
- MFCMU Causes Unbalance Condition
- Before Shipping to Service Center
- Data Backup and Recovery
- B1500A System Recovery
- Updating EasyEXPERT
- Error Codes
- 10 Application Library and Utilities
Agilent B1500 User’s Guide, Edition 7 9-75
If You Have a Problem
Error Codes
N877 SCUU failed LRL test.
N880 CMU failed Hcur AC and VRD Fm test.
N881 CMU failed SA/RA 32mV test.
N882 CMU failed SA/RA 64mV test.
N883 CMU failed SA/RA 125mV test.
N884 CMU failed SA/RA 250mV test.
N885 CMU failed ExR test.
N886 CMU failed Bias_chg test.
N887 CMU failed R_LPF2/R_HPF_vs test.
N888 CMU failed VRD IF test.
N889 CMU failed IRM local 0deg test.
N890 CMU failed IRM local 90deg test.
N891 CMU failed S_LPF1 f1 120kHz test.
N892 CMU failed S_LPF1 f2 500kHz test.
N893 CMU failed S_LPF1 f3 2MHz test.
N894 CMU failed S_LPF1 f4 5MHz test.
N895 CMU failed TRD MODEM test.
N896 CMU failed VG local 90deg test.
N897 CMU failed VG local 0deg test.
N898 CMU failed NA4 test.
N899 CMU failed NA5 X1/4 test.
N900 CMU failed NA5 X1/8 test.
N901 CMU failed N_LPF2 f2 500kHz test.
N902 CMU failed N_LPF2 f3 5MHz test.
N903 CMU failed MODEM PSD test.
N904 CMU failed PSD 0deg test.
N905 CMU failed PSD 90deg test.
N906 CMU failed Rr/Rf 100ohm test.