User`s guide
Table Of Contents
- User’s Guide
- 1 Getting Started
- 2 Introduction
- 3 Installation
- 4 Using EasyEXPERT
- 5 Classic Test Definition
- I/V Sweep
- Multi Channel I/V Sweep
- I/V List Sweep
- I/V-t Sampling
- C-V Sweep
- Direct Control
- Function Setup
- Auto Analysis Setup
- Display Setup
- SMU Range Setup Window
- ADC and Integration Time Setup Window
- Advanced Setup Window
- CMU Range Setup Window
- Advanced Setup Window for C-V Sweep
- Switching Matrix Control
- SPGU Control
- SPGU Pulse Setup Window
- Load Z Setup Window
- Pulse Switch Setup Window
- SPGU ALWG Setup Window
- Define ALWG Waveform Window
- 6 Application Test Definition
- 7 Function Details
- I/V Sweep Measurement
- Multi Channel I/V Sweep Measurement
- I/V-t Sampling Measurement
- C-V Sweep Measurement
- SPGU Module
- Sweep Abort Function
- Standby Function
- Bias Hold Function
- Current Offset Cancel
- SMU CMU Unify Unit
- Atto Sense and Switch Unit
- SMU/PG Selector
- SMU Ranging Mode
- SMU Compliance
- SMU Pulse
- SMU Measurement Time
- SMU Filter
- SMU Series Resistor
- Interlock Function
- Auto Power Off Function
- Initial Settings
- 8 Built-in Programming Tool
- 9 If You Have a Problem
- When You Operate B1500A
- When You Perform Measurement
- Measurement Takes More Time than Specified
- Noise Affects the Measured Values
- Voltage Measurement Error is Large
- SMU Oscillates for High-Frequency Device Measurements
- SMU Oscillates for Negative Resistance Measurements
- Large Current Causes High Temperature (Thermal Drift)
- Measurement Damages the Device under Test
- Leaving Connections Damages Devices after Measurement
- Unexpected Sampling Measurement Data is Returned
- MFCMU Causes Unbalance Condition
- Before Shipping to Service Center
- Data Backup and Recovery
- B1500A System Recovery
- Updating EasyEXPERT
- Error Codes
- 10 Application Library and Utilities

9-74 Agilent B1500 User’s Guide, Edition 7
If You Have a Problem
Error Codes
N849 CMU failed PLL0 test.
N850 CMU failed PLL0 lock test.
N851 CMU failed PLL0 lock test.
N852 CMU failed DDS test.
N853 CMU failed DDS1 test.
N854 CMU failed DDS2 test.
N855 CMU failed VRD normalizer test.
N856 CMU failed RA1 test.
N857 CMU failed RA2 test.
N858 CMU failed ExR test.
N859 CMU failed R_LPF2 f1 test.
N860 CMU failed MODEM DAC test.
N861 CMU failed N_II_DAC test.
N862 CMU failed N_QI_DAC test.
N863 CMU failed N_IQ_DAC test.
N864 CMU failed N_QQ_DAC test.
N865 CMU failed TRD normalizer test.
N866 CMU failed NA1 test.
N867 CMU failed NA2 test.
N868 CMU failed NA3 test.
N869 CMU failed N_LPF1 f2 test.
N870 CMU failed N_LPF1 f3 test.
N871 CMU failed N_LPF1 f4 test.
N872 CMU failed N_LPF1 f5 test.
N873 SCUU failed EEPROM test.
N874 SCUU failed output relay test.
N875 SCUU failed control test.
N876 SCUU failed CG2 test.