User`s guide

Agilent B1500 User’s Guide, Edition 7 9-49
If You Have a Problem
Error Codes
For a log sweep, the polarity of the start and stop values must be the
same in the WV, WI, WSV, WSI, or WNX command. Also, 0 is not
allowed for the start and stop values.
150 Command input buffer is full.
Agilent B1500 can receive 256 characters maximum including t
he
terminator at one time.
151 This command is not allowed to this channel.
152 Cannot use failed module.
The channel number specifying the module failed the self-test or
calibr
ation
. Specify another module that passed the self-test or
calibration. For the service purpose, execute the RCV command to
enable the module.
153 No module for the specified channel.
Module is not installed in the slot specified by the channel number.
160 Incorrect ST execution.
The internal memory programming can be started by the ST command
and completed by the
END command. Do not enter the ST command
between the ST command and the END command.
161 Incorrect END execution.
The internal memory programming can be started by the ST command
and completed
by the END command. Do not send the END command
before starting the programming.
162 Incorrect command for program memory.
Specified command cannot be stored in the program memory. For the
incorrect commands, s
ee Programming Guide.
170 Incorrect usage of internal variable.
The internal variable must be %In for integer data, or %Rn for real
d
ata. where n is an integer, 0 to 99. Use %In for the integer type
command parameters; and use %Rn for the real type command
parameters. For the internal variables, see the VAR command of
Programming Guide.
171 Internal variable is not allowed.