User`s guide

9-26 Agilent B1500 User’s Guide, Edition 7
If You Have a Problem
Error Codes
105049 The coefficient for High Speed ADC A averaging mode must be
between B and C.
105050 Invalid value (A) was specif
ied for the integral mode of ADC. Valid
option(s): B
105051 Invalid value (A) was specified for th
e sweep direction. Valid option(s):
B
105052 Invalid value (A) was specif
ied for the sweep stop condition. Valid
option(s): B
105053 Invalid value (A) was specified fo
r the impedance measurement model.
Valid option(s): B
105054 Hold time value must be between A s and B s.
105055 Delay
time value must be between A s and B s.
105056 Voltage s
ource value of A must be between B V
and C V.
105057 Frequency value of A must be betw
een B Hz and C Hz.
105058 Coefficient value of A integral
mode must be between B and C.
105059 AC Level value of A must be between B mV and
C mV.
105060 Invalid value (B) was specified fo
r monitor ranging mode of A. Valid
option(s): C
105061 SMU pulse period must be A s longer th
an the pulse width.
105062 Primary sweep source step value must be greater than the s
etup
resolution.
105063 Synchronous sweep source step value must be greater than the setup
resolutio
n. Adjust the offset value and the ratio value, or change the
primary sweep source settings.
105064 Compliance absolute value must be A A or greater if the channel is
the
SMU pulse source and the output value is B Vpp.
105065 Compliance value must be ± 2 V or less if the channel is the SMU pulse
source and the outpu
t value is 0 A to 10 μA.
105066 Current compliance must be 100 mA for VSU.
105067 Power compliance must be OFF for VSU.
105071 Sampling interval for I/V-t sampling must be between A s a
nd B s.
105072 Nu
mber of samples for I/V-t A sampling must be between B and C.