User`s guide

Agilent B1500 User’s Guide, Edition 7 6- 27
Application Test Definition
Auto Analysis
Auto Analysis
This component provides the setup editor used to set up the automatic analysis
function. When a measurement finishes, the function automatically draws lines, a
marker, or both on the X-Y Graph of the Data Display window.
You can set up two lines and one marker for the automatic analysis function by
using the setu
p editor.
In the Line 1 and Line 2 areas, you can set up the lines to be drawn.
In the Marker area, you can set up the marker.
Interpolation Mode Check this box to enable the interpolation mode. Y
ou can position marker between
measurement points.
Line 1, Line 2 This area sets the line 1 or line 2 automatically displayed and moved to the specified
p
osition after
the measurement.
Enable Check this box to enable the line.
Fix Check this box to fix the line on the graph after the auto
analysis is
performed. Remove the check to make the line free.
Type Select one of the available line types listed below.
Axis Axis effective for the line. Specify one from Y1 to Y8.
First Point See the following description for the line you selected.
Second Point See the following description for the line you selected.
Available line types:
• “Normal line”: For drawing a line between an
y two points
.
• “Gradient line”: For drawing a line through any point with a s
pecified gradient.
• “Tangent line”: For drawing a tangent line to a measurement p
oint.
• “Regression line”: For drawing a regression line by using the measurement data
included in the area specified by any two po
ints.