User`s guide

5- 8 Agilent B1500 User’s Guide, Edition 7
Classic Test Definition
I/V Sweep
Constant This area defines the constant output source.
Unit Source monitor unit (SMU) used for the constant source
V Name Variable name for the constant voltage output or measurement
data
I Name Va
riable name for the constant current output or
measurement
data
Mode Output mode, V (voltage), I (current), VPULSE (voltage pulse),
or IPULSE (cu
rrent pulse)
Source Output value
Compliance Compliance value. Enter the current limit value for the voltage
source, or th
e voltage limit value for the current source.
SMU Pulse This area defines the SMU pulse timing parameters. See “SMU Pulse” on page
7-56.
Unit Source monitor unit (SMU) used for the pulsed output
Period Pulse period. 5 ms to 5 s, 0.1 ms resolution.
Width Pulse width. 0.5 ms to 2 s, 0.1 ms resolution.
Base Pulse base value
Period and Width must satisfy the following conditions:
•Period ≥ Width + 2 ms
(for pulse width ≤ 100 ms)
•Period ≥ Width + 10 ms
(for pulse width > 100 ms)
Sweep status This field specifies the sweep abort condition, continue at any st
atus, or stop at any
abnormal status.
Range This button opens a window used to set the measurement ranging operation. See
“SMU Range Setup Window” on page 5-48.
ADC/Integ This button opens a window used to set the A/D con
verter of the
measurement
channels. See “ADC and Integration Time Setup Window” on page 5-50.
Advanced This button opens a window used to set the other functions of the measurement
ch
annel. See “Advanced
Setup Window” on page 5-51.
SPGU Pulse /
AL
WG Setu
p
This button opens a window used to set the SPGU output. See “SPGU Pulse Setup
Window” on page 5-59 or “SPGU ALWG Setup Window” on page 5-63.