User`s guide

Agilent B1500 User’s Guide, Edition 7 4- 31
Using EasyEXPERT
Repeat Measurement Setup
Repeat Measurement Setup
This dialog box is opened by clicking the Repeat button, and is used to set the repeat
measurement condition. This dialog box supports the following action buttons.
Run Starts measurement.
Abort Aborts the measurement.
Cancel Cancels performing the repeat meas
urement and closes this
dialog box.
The repeat measurement is performed as shown in Figure 4-1. The repeat
measurement operation is controlled by the value of Count and stat
us. Where, Count
is the number displayed in the Count field of the main screen, and status must be a
parameter of the response created by Start Procedure and Iteration Procedure. For
the response, see Figure 4-2.
Figure 4-1 Repeat Measurement Execution Flow
Repeat
P
rocedure
s
This area is used to specify the procedure to be called while the repeat measurement
is performed. The procedure must be the execution file (.exe file). If no procedure is
needed, empty the field. The Browse button opens a file browser.
status
limit
Abort
If Abort is clicked
Yes
Start
Start Procedure
No
Iteration Procedure
Final Procedure
End
Test Execution
No
Yes
status= True ?
Yes
No
Count >= limit
status= True ?
Count=Count+1
Count=0
